Instruction manual

F8237801

Collecting Audit Information

This feature allows the owner to retrieve audit

information stored in the machine by pressing a

sequence of pads on the control.

How to Enter Audit Feature

1. Control must be in Manual Mode to start. Refer

to Entering the Manual Mode.

2. Press the #3 ( ) or the #6 ( ) keypad until

“AUdt” appears.

3. Press the START (enter) keypad. “CyC” will

appear.

How to Read Audit Data

1. Use the #3 ( ) or the #6 ( ) keypad to scroll

through various options until the desired option is

shown in the display. Refer to the Audit Options

List, Table 10, for an explanation of the audit

options available.

2. Press the START (enter) keypad once to start the

audit count. At this point, the display will show

the first four-digit segment of the audit value. If

the audit count is 10,000 or higher, press the

START (enter) keypad again to view the last four

digits of the number.

NOTE: The display can show up to 4 digits at one

time. Audit counts 10,000 or higher are separated

into two 4-digit segments. Each time the START

(enter) keypad is pressed in step 2, the display will

show the next 4-digit segment in the audit value. If

the value is 9,999 or less, only one 4-digit segment

will be shown.

3. Press the START (enter) keypad again. The

control will go to the next audit option in the

Audit Options List.

How to Exit Audit Feature

Press the #5 (<) keypad.

Audit Options List

# Display Description

“CyC”

Total # of machine cycles

“rCyC”

Total # of rapid advanced cycles

Table 10