Instruction manual

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Programming Control
F8237801
34
16. Programmable Cycle Time
Display “PCtd”
This option allows the owner to program the displayed
cycle time.
How to Program Programmable Cycle
Time Display
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the #3 ( ) or the #6 ( ) keypad until
“Prog” appears in the display. Press the START
(enter) keypad and “dCyC” will appear in the
display.
3. Press the #3 ( ) or the #6 ( ) keypad to scroll
through the programmable options until “PCtd”
appears in the display.
4. When “PCtd” appears in the display, press the
START (enter) keypad. The current
Programmable Cycle Time Display status will
appear in the display.
“on” = Option Enabled
“oFF” = Option Disabled (Default Setting)
NOTE: Enabling this option will not change the
cycle time, only the display time for the user. Refer
to option “Cnin” in Cycle Programming to
program minutes to the cycle time display.
5. Press the #3 ( ) or the #6 ( ) keypad to change
the current status.
6. Press the START (enter) keypad when the
desired status appears in the display. The next
option, “SdAd”, will appear in the display.
NOTE: To program “SdAd” (Slow Drain
Detection Adjust Value), refer to option 17. To
program other options, refer to the appropriate
section.
How to Exit Programming Feature
Press the #5 (<) keypad until the control returns to
Ready Mode.
17. Slow Drain Detection Adjust
Value “SdAd”
This option allows the owner to increase the slow
drain detection threshold by adding additional seconds
to the threshold value. When enabled, it increases the
time before a slow drain error will occur.
How to Program the Slow Drain Detection
Adjust Value
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the #3 ( ) or the #6 ( ) keypad until
“Prog” appears in the display. Press the START
(enter) keypad and “dCYC” will appear in the
display.
3. Press the #3 ( ) or the #6 ( ) keypad to scroll
through the programmable options until “SdAd”
appears in the display.
4. When “SdAd” appears in the display, press the
START (enter) keypad. The current Slow Drain
Detection Adjust status will appear in the display.
5. Press the #3 ( ) or the #6 ( ) keypad to change
the current value.
NOTE: The slow drain detection adjust value can
be set from 0 to 255 seconds. The default value is 0.
6. Press the START (enter) keypad when the
desired value appears in the display. The next
option, “dCyC”, will appear in the display.
NOTE: To program “dCyC” (Default Cycle), refer
to option 1. To program other options, refer to the
appropriate section.
How to Exit Programming Feature
Press the #5 (<) keypad until the control returns to
Start Mode.
>
<
>
<
>
<
>
<
>
<
>
<