Instruction manual

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Programming Control
F8237801
30
8. Fahrenheit/Celsius “t FC”
This option allows the owner to set whether the
display will be shown in Fahrenheit or Celsius.
How to Program Fahrenheit/Celsius
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the #3 ( ) or the #6 ( ) keypad until
“Prog” appears in the display. Press the START
(enter) keypad and “dCYC” will appear in the
display.
3. Press the #3 ( ) or the #6 ( ) keypad to scroll
through the programmable options until “tFC”
appears in the display.
4. When “tFC” appears in the display, press the
START (enter) keypad. A number will appear in
the display. This number corresponds to the
current Fahrenheit/Celsius setting.
“CEL” = Celsius
“FAHr” = Fahrenheit (Default Setting)
5. Press the #3 ( ) or the #6 ( ) keypad to increase
or decrease the current number to the desired
number.
6. Press the START (enter) keypad when the correct
number of degrees appears in the display. The
new value is saved and the next option, “FH”,
will appear in the display.
NOTE: To program “FH” (Hot Water
Temperature), refer to option 9. To program other
options, refer to the appropriate section.
How to Exit Programming Feature
Press the #5 (<) keypad until the control returns to
Start Mode.
9. Hot Water Temperature “FH”
This option allows the owner to program the hot water
temperature for models equipped with heat.
How to Program Hot Water Temperature
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the #3 ( ) or the #6 ( ) keypad until
“Prog” appears in the display. Press the START
(enter) keypad and “dCYC” will appear in the
display.
3. Press the #3 ( ) or the #6 ( ) keypad to scroll
through the programmable options until “FH”
appears in the display.
4. When “FH” appears in the display, press the
START (enter) keypad. A number will appear in
the display. This number corresponds to the
current Hot Water Temperature value.
5. Press the #3 ( ) or the #6 ( ) keypad to increase
or decrease the current Hot Water Temperature
value to the desired Hot Water Temperature
value.
NOTE: Hot Water Temperature is selectable
between 35° and 194° Fahrenheit (2° and 90°
Celsius). Default temperature is 140° Fahrenheit
(60° Celsius).
NOTE: Refer to option 8 to select Celsius or
Fahrenheit display.
6. Press the START (enter) keypad when the correct
number appears in the display. The next option,
“FHC”, will appear in the display.
NOTE: To program “FHC” (Warm Water
Temperature), refer to option 10. To program other
options, refer to the appropriate section.
How to Exit Programming Feature
Press the #5 (<) keypad until the control returns to
Start Mode.
>
<
>
<
>
<
>
<
>
<
>
<
To prevent personal injury, avoid contact
with inlet water temperatures higher than
125° Fahrenheit (51° Celsius) and hot
surfaces.
W748
WARNING