Instruction manual

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Programming Control
F8237801
28
How to Program Cycle Time “Cnin”
This option allows the owner to program minutes to
the cycle’s display time.
1. Press the #3 ( ) or the #6 ( ) keypad to scroll
through the programmable Cycle Programming
options until “Cnin” appears in the display.
NOTE: The option “PCtd” Programmable Cycle
Time Display must be programmed “on” to access
the “Cnin” option, refer to option 16.
2. When “Cnin” appears in the display, press the
START (enter) keypad. The first cycle time value
will appear in the display.
3. Press the #3 ( ) or the #6 ( ) keypad to change
the current value.
NOTE: The Program Cycle Time can be set from 0
to 255 minutes. The default value is 0.
4. Press the START (enter) keypad when the
desired cycle time value appears in the display.
NOTE: Programming display time (in minutes)
does not actually change time in the cycle, only the
displayed cycle time for the user.
NOTE: To program another cycle, repeat Cycle
Programming steps. To program other options,
press the #3 ( ) or the #6 ( ) keypad and refer to
the appropriate section.
How to Exit Programming Feature
Press the #5 (<) keypad until the control returns to
Ready Mode.
5. Supply/Compartment Dispenser
Programming “SUPC” (Design
1 Models only)
This option allows the owner to choose between the
supply dispenser or compartment dispenser.
NOTE: “Supply Dispenser” must only be selected if
machine is connected to an external chemical
supply system.
How to Program Supply/Compartment
Dispenser Programming
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the #3 ( ) or the #6 ( ) keypad until
“Prog” appears in the display. Press the START
(enter) keypad, and “dCYC” will appear in the
display.
3. Press the #3 ( ) or the #6 ( ) keypad to scroll
through the programmable options until “SUPC”
appears in the display.
4. When “SUPC” appears in the display, press the
START (enter) keypad. The current dispenser
option will appear in the display.
“S” = Supply Dispenser
“C” = Compartment Dispenser (Default Setting)
5. Press the #3 ( ) or the #6 ( ) keypad to change
the dispenser type.
6. Press the START (enter) keypad when the
desired dispenser type appears in the display. The
next option, “bALr” (VFD models) or “lrA”
(2 Speed models), will appear in the display.
NOTE: For VFD models: To program “bALr”
(Number of Balance Retries), refer to option 6.
For 2 Speed models: To program “lrA” (lR Access
[on/off]), refer to option 7. To program other
options, refer to the appropriate section.
How to Exit Programming Feature
Press the #5 (<) keypad until the control returns to
Start Mode.
>
<
>
<
>
<
>
<
>
<
>
<