Instruction manual

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Programming Control
F8237801
26
Programming Agitate Step
1. When “AgSt” appears in the display, press the
START (enter) keypad. The first Agitate step
programming option will appear in the display.
2. Press the #3 ( ) or the #6 ( ) keypad to scroll
through the programmable Agitate step options.
Refer to Table 8.
NOTE: Agitate Step “AgEn” must be enabled to
scroll through all Agitate step options.
3. Press the START (enter) keypad when the
desired option appears in the display. The current
status/value will appear in the display. Refer to
Table 8.
4. Press the #3 ( ) or the #6 ( ) keypad to change
the current status/value.
5. Press the START (enter) keypad when the
desired status/value appears in the display. The
next Agitate step option will appear in the
display.
NOTE: To program “drAn” (Drain Step), continue
to next Cycle Segment option. To program other
options, press #3 ( ) or the #6 ( ) keypad and refer
to the appropriate section.
How to Exit Programming Feature
Press the #5 (<) keypad until the control returns to
Start Mode.
Programming Drain Step
1. When “drAn” appears in the display, press the
START (enter) keypad. The current status will be
displayed.
2. Press the #3 ( ) or the #6 ( ) keypad to change
the current status.
“on” = Drain step is enabled
“oFF” = Drain step is disabled
NOTE: Drain must be enabled to activate Extract
Step.
3. Press the START (enter) keypad when the
desired status appears in the display. The next
Cycle Segment option, “SPIn”, will appear in the
display.
NOTE: To program “SPIn” (Extract Step),
continue to next Cycle Segment option. To program
other options press the #3 ( ) or the #6 ( ) keypad
and refer to the appropriate section.
How to Exit Programming Feature
Press the #5 (<) keypad until the control returns to
Start Mode.
Agitate
Step
Description Status/Value
“AgEn” Agitate Step
Enable/Disable
“on”/“oFF”
“AdUr” Agitate Duration
(in minutes)
“1” - “30”
“HEAt” Heat in Agitate
(If heater is present)
“oFF”, “1” or “2”
1 = To Target
2 = Maintain
Table 8
>
<
>
<
>
<
>
>
<
>
<