Instruction manual

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Programming Control
23
F8237801
4. Cycle Programming “CyC-”
This option allows the owner to program different
aspects for various steps in each type of cycle. There
are 9 cycles available for programming.
How to Enter Cycle Programming
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the #3 ( ) or the #6 ( ) keypad until
“Prog” appears in the display. Press the START
(enter) keypad and “dCYC” will appear in the
display.
3. Press the #3 ( ) or the #6 ( ) keypad to scroll
through the programmable options until “CyC-”
appears in the display. Press the START (enter)
keypad and “CyC1” will appear in the display.
4. Press the #3 ( ) or the #6 ( ) keypad to scroll
through the 9 cycles to program. Press the
START (enter) keypad when the desired cycle
appears in the display.
5. The first Cycle Programming option, “Agit”, will
appear in the display.
NOTE: To program “Agit” (Cycle Agitate),
continue to next option. To program other options,
press the #3 ( ) or the #6 ( ) keypad and refer to
the appropriate section.
How to Exit Programming Feature
Press the #5 (<) keypad until the control returns to
Start Mode.
How to Program Cycle Agitate“AgIt”
This option allows the owner to program the cycle’s
agitation action and speed. These options apply to the
entire cycle.
1. Press the #3 ( ) or the #6 ( ) keypad to scroll
through the programmable Cycle Programming
options until “Agit” appears in the display.
2. When “Agit” appears in the display, press the
START (enter) keypad. The first Cycle Agitate
option will appear in the display.
3. Press the #3 ( ) or the #6 ( ) keypad to scroll
through the programmable options. Refer to
Table 5.
4. Press the START (enter) keypad when the
desired programmable option appears in the
display. The current status will appear in the
display. Refer to Table 5.
5. Press the #3 ( ) or the #6 ( ) keypad to change
the current status.
6. Press the START (enter) keypad when the
desired status appears in the display. The next
Cycle Agitate option will appear in the display.
NOTE: To program “SEg1” (Cycle Segment 1)
press the #5 (<) keypad and continue to next Cycle
Programming option. To program other options,
press the #5 (<) keypad and refer to the
appropriate section.
How to Exit Programming Feature
Press the #5 (<) keypad until the control returns to
Start Mode.
>
<
>
<
>
<
>
<
Final
Spin Step
Description Status
“tyPE” Agitate Type “1” - “2”
1 = 18/3/18 Agitation Action
2 = 3/12/3 Agitation Action
“ASPd” Agitate Speed
(VFD only)
“Lo” = Reduced Speed
“rEg” = Normal Speed
Table 5
>
<
>
<
>
<