Instruction manual

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Programming Control
F8237801
22
3. Error Code Programming “Err-”
This option allows the owner to turn on or turn off
certain errors in the control.
How to Program Error Code Programming
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the #3 ( ) or the #6 ( ) keypad until
“Prog” appears in the display. Press the START
(enter) keypad and “dCYC” will appear in the
display.
3. Press the #3 ( ) or the #6 ( ) keypad to scroll
through the programmable options until “Err-”
appears in the display.
4. When “Err-” appears in the display, press the
START (enter) keypad. Refer to Table 4 for a list
of programmable error code parameters.
5. Press the #3 ( ) or the #6 ( ) keypad to select
error code.
6. Press the START (enter) keypad when the correct
code appears in the display. The current status
will appear in the display.
“on” = Error Code enabled
“oFF” = Error Code disabled
NOTE: The default values for Water Leak
Detection Error and Slow Drain Detection Error
are “on”. The default values for all other errors are
“oFF”.
7. Press the #3 ( ) or the #6 ( ) keypad to change
the status.
8. Press the START (enter) keypad when the correct
status appears in the display. The next Error Code
Programming option will appear in the display.
NOTE: To program “CyC-” (Cycle Programming),
press the #5 (<) keypad, then the #3 ( ) keypad and
refer to option 4. To program other options, refer to
the appropriate section.
How to Exit Programming Feature
Press the #5 (<) keypad until the control returns to
Start Mode.
>
<
>
<
>
<
>
<
>
“E FL” Fill Error
“E dr” Drain Error
“E Ub” Unbalance Error Display (VFD only)
“E oP” Open Thermistor Error Display
“E SH” Shorted Thermistor Error Display
“E Ht” Heat Error Display (Heater only)
“LEr-” Leak Detection Error
If Water Leak Detection during a machine
cycle is enabled, then, on the enabled
day(s) of the week, the control will check
for water leaks during running machine
cycles. If a leak is detected, the control will
display the “ELd” error for one (1) minute
after the cycle is completed. It will also
light the right-most decimal point on the
display. The Water Leak Detection
diagnostic can be used to verify the leak.
“LEr1”
Water Leak Detection During a
machine cycle - Determines if
water level drops below target
level.
“LEr3”
Number of cycles between Leak
Detection Tests.
“E Sd” Slow Drain Detection - Determines if
machine is draining slower than
normal.
If Slow Drain Detection is enabled, the
control will check for slow drain operation
during running machine cycles. If a slow
drain is detected, the control will display
the “ESd” error for one minute after the
cycle is completed. It will also light the
right-most decimal point on the display.
Table 4