Instruction manual

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Programming Control
F8237801
18
Figure 6
CHM1395R
CHM1395R
(continued)
“IrA” - Enable/disable the ability to read
the control by an external device:
“on” = Enabled
“oFF” = Disabled
“t FC” (Models with Heat) - Set
temperature shown in Fahrenheit or Celsius.
“FH” (Models with Heat) - Set
the temperature of the hot water:
35°F - 194°F / 2°C - 90°C.
“FHC” (Models with Heat) - Set the
temperature of the warm water:
35°F - 194°F / 2°C - 90°C.
“FC” (Models with Heat) - Set the
temperature of the cold water:
35°F - 194°F / 2°C - 90°C.
“Codn” (Models with Heat) - Enable/Disable
the cool down water temperature option:
“oFF” or 50°F - 160°F / 10°C - 71°C.
“PtEn” - Enable/disable access to the
production test cycle:
“on” = Enabled
“oFF” = Disabled
“rAEn” - Enable/disable the rapid advance
feature:
“on” = Enabled
“oFF” = Disabled
“nCtd” - Enable/disable whether the cycle
time will appear in display:
“on” = Enabled
“oFF” = Disabled
“bALr” (VFD only) - Program the number
of times control will retry balancing the
load before moving to extract step: 1-7.
Temperature:
“CEL” = Celsius
“FAHr” = Fahrenheit
“SUPC” (Design 1 only) -
Choose either supply dispenser
or compartment dispenser.
Dispenser:
“S” = Supply Dispenser
“C” = Compartment Dispenser
“SdAd” - Enable/disable slow drain
detection. When enabled can
increase/decrease the time before a slow
drain error will occur:
0-255 seconds
“PCtd” - Enable/disable
Programmable Cycle Time Display
“on” = Enabled
“oFF” = Disabled