Instruction manual

ManualsBrandsAlliance Laundry Systems ManualsHousehold AppliancesHCU060HNF

F8237801

Programming Control

What Can Be Programmed?

This feature allows the owner to program cycle

information and other features by using the keypads.

The control must have the Manual Programming

Mode enabled, which is the factory default. This mode

can only be turned “oFF” and “on” by using an

external device. Refer to this section when programming

the control.

This section offers a detailed description of all available

programmable options.

Each description includes instructions on when and

why the option might be used and, more importantly,

how to program the option.

For more advanced users, a quick reference list (refer

to Table 2) and programming flowcharts (refer to

Figure 4 through Figure 7) of the options available

through the programming mode are located on the

following pages.

NOTE: The letters and numbers in the Option

Display column of the Programmable Options List

are what will be shown in the display when that

option is selected.

Programmable Options Available

Option

Number

Option

Display

Description

Default

Value

Value Range

1“dCYC” Default Cycle 51 - 9

2“AUd” Audio Signal 29* 0 - 31

3“Err-” Errors ––

a. “EFL” Fill Errors on on/oFF

b. “Edr” Drain Error on on/oFF

c. “EUb” Unbalance Error Display on on/oFF

d. “EoP” Open Thermister Error Display on on/oFF

e. “ESH” Shorted Thermistor Error Display on on/oFF

f. “EHt” Heat Error Display (Heater only) on on/oFF

g. “LEr-” Water Leak Detection Error – –

1. “LEr1” Water Leak Detection During a

Machine Cycle (On/Off)

oFF on/oFF

“LEr3” Number of cycles between Leak

Detection Test

0* 0 - 127

h. “E Sd” Slow Drain Detection oFF on/oFF

4“CyC-” Cycle Programming ** –

a. “AgIt” Cycle Agitate ––

1. “tyPE”Agitate Type ** 1 - 2

2. “ASPd” Agitate Speed (VFD only) ** Lo/rEg

b. “Seg-” Cycle Segment Programming –1 - 8*

1. “SgEn” Segment Enable/Disable ** on/oFF

* Refer to programming section for value definition.

** Refer to the Cycle Chart for default cycle setting informaton.

Table 2 (continued)