Instruction manual

F8237801

Entering the Manual Mode

For programming, testing, and retrieving information

from the control, it is often necessary to enter the

Manual Mode by following the six simple steps below.

For an overview of Entering the Manual Mode, refer

to the flowchart on the following page.

How to Enter the Manual Mode

1. If the washer is in an active cycle, rapid advance

through the cycle. Refer to the Rapid Advance

Feature.

2. Open the top cover. Refer to Opening the Top

Cover.

3. While pressing and holding the #4 keypad with

one hand, press the #1 keypad with the other

hand.

4. The display will show “rAPd”.

5. Press the #3 ( ) keypad or the #6 ( ) keypad to

scroll through the options until the desired option

appears in the display.

6. Press the START (enter) keypad.

Manual Mode is broken into three groups: Manual

Programming, Manual Rapid Advance and Manual

Diagnostics. Manual Programming can only be turned

on or off with an external device. Refer to the

appropriate instruction manual. Manual Rapid Advance

can be turned on and off using an external device or by

manual programming (refer to option 14 of

Programming Control).

By default, all groups are turned “on”.

The manual features available in each group are as

follows (the menu displayed on the display in this

mode is in parentheses).

Manual Programming

Manual Programming (Prog)

Manual Read Audit (AUdt)

Manual Reset (rSEt)

Manual Rapid Advance

Rapid Advance (rAPd)

Manual Diagnostics

Manual Diagnostic Tests (diAg)

If a group is turned off, the display will change from

the selected feature to “oFF” when the START (enter)

pad is pressed and an audio signal will sound for one

(1) second. The display will then return to the selected

feature. The features in the group cannot be entered.