Instruction manual

F8237801

Opening the Top Cover

To manually program the control, the top cover must

be opened. Opening and closing the top cover trips a

switch which allows access to various programming

options. Once opened, the top cover may either be left

open, and then closed after programming, or it may be

closed immediately.

The top cover is located on the top of the machine.

1. Unlock top cover.

2. Slide top cover forward slightly to move notches

away from the pegs on the front of the cabinet.

3. Lift the top cover up. To completely remove, lift

top cover away from both top cover hinges. Refer

to Figure 2.

After removing or opening and closing the top cover,

the operator has 4 minutes and 15 seconds to begin

programming. If the appropriate SELECT CYCLE

keypads have not been pressed in that time, the control

will not accept operator programming. Should this

happen, opening and closing the top cover will once

again trip the switch which allows access to the

programming options.

Figure 2

CHM1357R

1 Top Cover Lock 3 Top Cover Hinge

2 Top Cover 4 Peg

CHM1357R