Instruction manual

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
9
F8237801
Special Features
Programming Control
The control allows the machine owner to program the
control with the use of the keypad. Cycle options may
be programmed, audit information may be viewed and
diagnostic tests may be run by pressing combinations
of the SELECT CYCLE keypads.
For details on programming select cycle options, refer to
Programming Control.
Collecting Audit Information
The control will store audit information in its memory
that can be retrieved by pressing various combinations
of SELECT CYCLE keypads. The control will record
total machine cycles and total rapid advance cycles.
For more information on the audit features, refer to
Collecting Audit Information.
NOTE: Additional audit information is retrievable
with an external device, using infra-red
communications. Refer to the appropriate
instruction manual.
Testing Machine and Control
Functions
Special diagnostic features built into the control allow
the owner to run specific diagnostic tests. By opening
and closing the top cover and then pressing various
sequences of SELECT CYCLE keypads, the owner
may retrieve or perform the following tests:
• VFD Balance Weight Test
(Design 1 models only)
• Drive DC Bus Display Test
(Design 2 models only)
• Water Purge Test
• Water Leak Detection Test
• Drive Software Version Number
(Design 2 models only)
• Drive Parameter Table Version Number
(Design 2 models only)
• Drive Type (Design 2 models only)
For detailed information on running diagnostic tests,
refer to Testing Machine and Control Functions.
Rapid Advance Feature
This feature allows the user to quickly advance
through active cycles. This feature is useful when tests
must be performed immediately on a machine
currently in an active cycle. In this case, the user can
quickly advance through the cycles to shakeout. At
this point, the user can perform the required tests and
then return the machine to the point it was interrupted
or press the STOP keypad to end the cycle.
For detailed information on using the Rapid Advance
feature, refer to Rapid Advance Feature.
Communications Mode
This feature allows the control to communicate with
an external device using infra-red communications.
This allows the control to be programmed without
using the keypad.
For more detailed information on using the
Communications Mode feature, refer to
Communications Mode.
Power Save Mode
This feature powers down the display after machine is
idle for 4 minutes and 15 seconds. To “wake up” the
machine display, press any Cycle pad.
The Power Save Mode is a feature of the control and
cannot be disabled in programming.
Temperature Display Mode
This feature allows machines equipped with a
temperature sensor to display the current water
temperature after the first fill during a cycle.
Press the active cycle keypad to display temperature
and press again to return to remaining cycle time.