Instruction manual

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
F8237801
8
Machine Operation
Start Up
When power is applied to the machine, the control will
display its software version as “Sxx” (“xx” is the
version number) for one (1) second. If the control was
not powered down during a running cycle, it will enter
Start Mode.
Door Locking Mode
The control enters this mode after the START (enter)
keypad is pressed in Start Mode. The control stays in
Door Locking Mode until it confirms the door is
closed and locked.
Stop Mode
The control enters this mode if the user stops the cycle
by pressing the STOP keypad.
Start Mode
The control enters this mode when machine is ready
for operation. The display will show the cycle time for
the selected cycle.
After pressing the START keypad, the door will lock
and the cycle will begin.
End of Cycle Mode
When a cycle is complete, the control will display “00”
until the washer door is opened. When this event occurs,
the display will revert back to Start Mode.
Cycle Sequence
Upon the start of a cycle, the control will display the
total cycle time. The appropriate LEDs will light while
the machine passes through different cycle steps. The
user will not be able to change cycles after first Fill is
complete.
Run Mode
The control enters this mode when a cycle is running.
The time remaining appears in the display, the status
LED’s are lit and the loading door is locked.
Signals
There are two options when a signal can be used during
the washer operation. These two options are listed below:
1. End of Cycle Signal
By default, this signal is turned off. If turned on, the
signal sounds for three (3) seconds at the end of a
cycle.
2. Signal On Keypad Depression
By default, this signal is turned on and sounds for
a quarter of a second each time a keypad is pressed.
NOTE: Refer to Programming Control to program
signal options.
Changing Cycles
Cycles can be changed anytime during the first Fill
step. After the first Fill step, all key presses are
ignored.
Door Unlocking Mode
The control enters this mode after a cycle has ended.
The control waits for confirmation that door is
unlocked. Once confirmation is received that door is
unlocked, control will enter End of Cycle Mode.