Installation manual

Programming

F232139

3. Use Up or Down (arrow) key to select fill

temperature: cold (CFIL), hot (HFIL) or

warm (bFIL). Press Start (#) key.

4. Use Up or Down (arrow) key to select fill level:

low level (LOLE) or high level (HILE). Press

Start (#) key.

5. Use Up or Down (arrow) key to select supply

option. Refer to Table 2. Press Start (#) key.

NOTE: Compartment 1 flushes with each fill.

Compartment 2 flushes when the program calls

for supply 2 during a fill. Compartment 3 flushes

when the program calls for supply 3 during a fill.

Compartment 2 does not flush when supply 4 is

called for in a program.

6. If machine is equipped with auxiliary heating

system, use Up or Down (arrow) key to select

desired segment temperature. Set value to zero to

disable auxiliary heat for this segment. Press

Start (#) key.

7. Use Up or Down (arrow) key to select spin time.

Set value to zero to skip spin step. Press Start (#)

key. Display will now show the identifier for next

program segment.

8. Press the Start (#) key to complete cycle

programming procedure.

Refer to the following Cycle Charts section for

detailed description of cycles.

Supply Options

Display Supply

SUP0 No Supply

SUP1 Supply 1

SUP2 Supply 2

SUP3 Supply 3

SUP4 Supply 4

SUP5 Supply 1 and 2

SUP6 Supply 2 and 3

SUP7 Supply 3 and 4

Table 2