Instruction manual

Programming NetMaster

F232151

6. Press the START (enter) keypad to enter the fifth

digit and display remaining four digits. The

active digit will flash one second on and one

second off. Refer to Figure 101.

Figure 101

7. Press the DELICATES (+) or the COLD (-)

keypad to increase or decrease the value of the

active digit and the START (enter) keypad to

enter the value of the digit and advance to the

next digit.

8. Press the START (enter) keypad with the last

active digit. The next option, “+032”, will appear

in the VFD.

NOTE: To program “+032” (Start Pulse Value),

refer to option 32 in Programming NetMaster in the

Enhanced Programming Guide, available at extra

cost. To program other options, refer to the

appropriate section.

How to Exit Programming Feature

1. Be sure the control shows a programmable option,

not a value.

2. While pressing and holding the NORMAL

keypad with one hand, press the PERM PRESS

keypad with the other hand. The control will

revert back to the Ready Mode. Refer to

Figure 2.

C827I