Instruction manual

ManualsBrandsAlliance Laundry Systems ManualsHousehold AppliancesHC18NR2

Programming NetMaster

F232151

15. Special Vend A Days Enable

“+015”

This option allows the owner to set the day or days of a

special vend.

Special Vend A is used to change the standard vend

prices for special occasions or to turn the machine off.

The special vend can be programmed to start and end

on a specific day or days of the week.

The owner may also turn the Special Vend A option on

or off if desired.

How to Program Special Vend A Days

Enable

1. Control must be in Manual Mode. Refer to

Entering the Manual Mode.

2. Press the DELICATES (+) or the COLD (-)

keypad until “PrOg” appears in the VFD. Press

the START (enter) keypad and “+001” will

appear in the VFD.

Figure 38

3. Press the DELICATES (+) or the COLD (-)

keypad to scroll through the programmable

options until “+015” appears in the VFD. Refer

to Figure 39.

Figure 39

4. When “+015” appears in the VFD, press the

START (enter) keypad. A number will appear in

the VFD that corresponds to the current Special

Vend A Days Enable Programming Value.

5. Locate the desired number in the first column of

Table 3 on the following pages.

6. Press the DELICATES (+) or the COLD (-)

keypad to increase or decrease the current

number until correct. Refer to Figure 40.

Figure 40

7. Press the START (enter) keypad when the correct

number appears in the VFD. The next option,

“+016”, will appear in the VFD.

NOTE: To program “+016” (Special Vend A Start

Hour), refer to option . To program other options,

refer to the appropriate section.

How to Exit Programming Feature

1. Be sure the control shows a programmable option,

not a value.

2. While pressing and holding the NORMAL

keypad with one hand, press the PERM PRESS

keypad with the other hand. The control will

revert back to the Ready Mode. Refer to

Figure 2.

C762I

C777I

B029R

1 Press this pad (+) to scroll forward or increase a value

2 Press this pad (enter) to choose a selected value or

option

3 Press this pad (-) to scroll back or decrease a value

neednew#2