Instruction manual

ManualsBrandsAlliance Laundry Systems ManualsHousehold AppliancesHC18NR2

Programming NetMaster

F232151

1. Audio Signal “+001”

This option allows the owner to program when the

signal will sound.

There are four occasions when a signal may sound

during the washer operation. These four occasions are

listed below:

1. End of Cycle Signal

By default, the signal is turned off. If turned on,

the signal will sound for three seconds at the end

of a cycle.

2. Keypad Depression Signal

By default, this signal is turned on and will sound

for a quarter of a second. This signal will sound

each time a keypad is pressed.

3. Coin Input/Card Insertion Signal

By default, this signal is turned on and will sound

for a quarter of a second each time a coin or card

is entered.

4. Remove Card Signal (Card Models Only)

By default, this signal is turned on and will sound

one (1) second on and one (1) second off when

the REMOVE CARD LED is flashing and the

transaction is complete.

How to Program the Audio Signal

1. Control must be in Manual Mode. Refer to

Entering the Manual Mode.

2. Press the DELICATES (+) or the COLD (-)

keypad until “PrOg” appears in the VFD. Press

the START (enter) keypad.

Figure 5

3. “+001” will appear in the VFD. Press the START

(enter) keypad. A number will appear in the

VFD. This number corresponds to the current

Audio Signal Programming Value. Refer to

Figure 6.

Figure 6

4. Locate the desired number in the first column of

Table 2 on the following page.

5. Press the DELICATES (+) or the COLD (-)

keypad to increase or decrease the current

number until correct. Refer to Figure 7.

Figure 7

Example: An owner might wish to have the signal

sound only when a keypad is pressed. Entering the

number “1” in step 5 would turn off all the options

except KEYPAD. In this instance, the signal would

sound only when a keypad is pressed.

6. Press the START (enter) keypad when the correct

number appears in the VFD. The next option,

“+002”, will appear in the VFD.

NOTE: To program “+002” (Regular Hot Wash

Vend Price), refer to option 2. To program other

options, refer to the appropriate section.

C762I

C821I

B029R

1 Press this pad (+) to scroll forward or increase a value

2 Press this pad (enter) to choose a selected value or

option

3 Press this pad (-) to scroll back or decrease a value

C821I

neednew#2