Instruction manual

21
F232151
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Entering the Manual Mode
For programming, testing and retrieving information
from NetMaster, it is often necessary to enter the
Manual Mode by following the four simple steps below.
How to Enter the Manual Mode
1. Be sure the washer-extractor is in the Ready
Mode before continuing to step 2. Refer to
Figure 2. If the washer-extractor is in an active
cycle, rapid advance through the cycle. Refer to
Rapid Advance Feature. If coins have been
entered, refer to Clear Vend Feature.
2. Open the access panel. Refer to Opening the
Access Panel.
3. While pressing and holding the NORMAL
keypad with one hand, press the HOT keypad
with the other hand.
4. The VFD display will show “rAPd”. Refer to
Figure 4.
Figure 4
5. Press the DELICATES (+) or the COLD (-)
keypad to scroll through the options until the
desired option appears in the VFD.
6. Press the START (enter) keypad.
Manual Mode is broken into two groups: Manual
Programming and Manual Rapid Advance/Diagnostics.
Manual Programming can only be turned ON or OFF
with the Micro-Wand IIIE, the Smart Card Reader or
the Network. Refer to the appropriate instruction
manual. Manual Rapid Advance/Diagnostics can be
turned ON and OFF using the Micro-Wand IIIE, by
manual programming (refer to option 81 in
Programming NetMaster), with the Smart Card
Reader, or with the Network.
By default, both groups are turned ON.
The manual features available in each group are as
follows (the menu displayed on the VFD in this mode
is in parentheses).
Manual Programming
Manual Programming (PrOg)
Manual Read Audit (AudT)
Manual Reset (rSET)
Rapid Advance/Diagnostics
Rapid Advance (rAPd)
Show Mode (SHOW)
Diagnostic Tests (dIAg)
If a group is turned OFF, the feature menu will still
appear, but the features in the group cannot be entered.
NOTE: If no feature is chosen, the washer-
extractor will return to the Ready Mode after
approximately four minutes.
B30R
neednew#1