Instruction manual

F232151

Opening the Access Panel

To manually program NetMaster, the access panel

must be opened. Opening and closing the access panel

trips a switch which allows access to various

programming options. Once opened, the access panel

may either be left open, and then closed after

programming, or it may be closed immediately.

NOTE: If the Break-In Alarm option is enabled, it

must be disabled before opening the access panel.

For more information on using the Break-In

Alarm, refer to the Micro-Wand IIIE or Network

Instruction Manual.

The access panel is located on the top of the washer-

extractor. Refer to Figure 3.

After opening, or opening and closing the access

panel, the operator has 4.25 minutes to begin

programming. If the appropriate SELECT PADS have

not been pressed in that time, the control will not accept

operator programming. Should this happen, opening and

closing the access panel will once again trip the switch

which allows access to the programming options.

Figure 3

C873I

1 Access Panel Lock

2 Access Panel

C873I