Instruction manual

17
F232151
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
NetMaster Special Features
Programming NetMaster
NetMaster allows the washer-extractor owner to
program the control with the use of the keypad. Audit,
diagnostic, cycle and vend information may be
programmed and retrieved by pressing combinations
of the Select Cycle and Select Wash Temp pads.
For details on programming cycle and vend information,
refer to Programming NetMaster.
Collecting Audit Information
The control will store audit information in its memory
that can be retrieved by pressing various combinations
of Select Cycle and Select Wash Temp pads. NetMaster
will record coins entered, total wash cycles and total
start pulses.
For more information on the audit features, refer to
Collecting Audit Information.
NOTE: Additional audit information is retrievable
with the Micro-Wand IIIE, the Card Reader or the
Network. Refer to the appropriate instruction
manual.
Testing Machine and NetMaster
Functions
Special programmable diagnostic features built into
NetMaster allow the owner to run specific diagnostic
tests. By opening and closing the service door and then
pressing various sequences of Select Cycle and Select
Wash Temp pads, the owner may perform the
following tests:
● Control Software Version Number
● Heater on Test
● Access Panel Opening Test
● Coin Vault Opening Test
● Coin Drop #1 Input Test
● Coin Drop #2 Input Test
● Door Switch Input Test
● Door Lock Switch Input Test
● Show Fill Time Test
● Show Drain Time Test
● Temperature Sensor Display Test
● Start Pulse Test
● Pressure Switches Opening Test
● Configuration #1 Display Test
● Configuration #2 Display Test
● Configuration #3 Display Test
● VFD Balance Input Test
● VFD Filter Input Test
● Water Purge
For detailed information on running diagnostic tests,
refer to Testing Machine and NetMaster Functions.
Sales Floor Feature
NetMaster washer-extractor has a built-in sales floor
routine used to display all LED lights and the four
digits with the colon and decimal point. This function
is designed to show potential customers the high-tech
features of NetMaster.
For detailed information, refer to Sales Floor Feature.
Rapid Advance Feature
This feature allows the user to quickly advance
through active cycles or advance into a cycle from the
Ready Mode. This feature is useful when tests must be
performed immediately on a washer-extractor
currently in an active cycle. In this case, the user can
quickly advance through the cycles to the Ready
Mode. At this point, the user can perform the required
tests and then return the washer-extractor to the point
it was interrupted.
For detailed information, refer to Rapid Advance
Feature.
Clearing the NetMaster Vend Feature
This feature allows the user to return NetMaster back
to the Ready Mode if coins or a card have been entered
but the full vend price has not yet been satisfied. Refer
to Figure 2.
For more information, refer to Clear Vend Feature.
Communications Mode
This feature allows the washer-extractor control to
communicate with the Micro-Wand IIIE, the Card
Reader or the Network. This allows the washer-
extractor control to be programmed and have its data
read without using the keypad.
For more detailed information, refer to
Communications Mode.
Dual Coin Drop
The control will accept pulses from a single or dual
coin drop to satisfy vend price. Each coin drop will
have the ability to start or run a cycle.