Instruction manual

Washer-Extractor Operation

F232151

Signals

There are four options when a signal can be used during

the washer-extractor operation. These four options are

listed below:

1. End of Cycle Signal

By default, this signal is turned off. If turned on, the

signal sounds for three (3) seconds at the end of a

cycle.

2. Signal On Keypad Depression

By default, this signal is turned on and sounds for

a quarter of a second each time a keypad is pressed.

3. Signal On Coin Input/Card Insertion

By default, this signal is turned on and will sound

for a quarter of a second each time a coin or card

is entered.

4. Signal for Card Removal (Card Models Only)

By default, this signal is turned on and will sound

one second on and one second off when the

REMOVE CARD LED is flashing.

NOTE: Refer to Programming NetMaster to program

signal options.

Changing Cycles

Cycles and wash temperatures can be changed anytime

during the first fill/tumble cycle. After the first fill/

tumble cycle, all key presses are ignored.

Selecting a higher priced wash temperature will stop the

first fill/tumble cycle, and INSERT COINS/CARD will

flash one (1) second on and one (1) second off until the

vend price has been satisfied. After the vend price has

been satisfied, the cycle will restart with the new wash

temperature. If the vend price is not satisfied within one

minute, the control will go back to the previously set

wash temperature.