Instruction manual

15
F232151
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Washer-Extractor Operation
Start Up
When power is applied to the washer, the control will
display INSERT COINS/CARD, the decimal point
and the vend price. The INSERT COINS/CARD light
will remain lit until the vend price has been satisfied.
The default cycle setting is PERM PRESS, the default
wash water fill temperature is WARM and the default
rinse water temperature is COLD. The LEDs will be lit
on PERM PRESS and WARM at the start of the cycle.
Refer to Figure 2. These default settings are owner
programmable. Refer to Programming NetMaster.
Ready Mode
Figure 2
To start the cycle, the user must press the START
keypad after the vend price has been satisfied.
The user will be able to select a different cycle or wash
water temperature by pressing a cycle pad when the
machine is in the Ready Mode or in the first fill cycle.
If not enough vend is entered to satisfy the vend price,
the control will display the remaining vend price needed
to start the cycle. If the first fill was interrupted to
change the temperature (which requires more money),
and the vend price is not satisfied within one minute,
the washer control will go back to the first selection
and the cycle will restart. After the first fill, all key
presses will be ignored, allowing the washer to go
through the complete cycle.
When a cycle is complete, the control will display “:00”
until the washer-extractor door is opened, a key is pressed
or a coin/card is entered. When one of these three options
occurs, the display will revert back to the Ready Mode.
Refer to Figure 2.
Cycle Sequence
Upon the start of a cycle, NetMaster will display the
total cycle time. The appropriate LEDs will light while
the machine passes through different cycle steps. Any
coin entered after the first fill/tumble cycle will be
added to the total coin counter, but the user will not be
able to change cycles or water temperature.
Closing Washer-Extractor Door
If the door is not closed when the START pad is
pressed, “door” will be displayed until the door is
closed. Once door is closed, the START pad must be
pressed again to lock door and start the cycle. If the door
does not lock within 15 seconds of being closed, “E:dL”
will be displayed indicating a door lock error and the
machine will shut off.
C872I