Instruction manual

13
F232151
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
VFD Display Identification
Light Emitting Diodes (LEDs)
(Refer to Figure 1)
LIGHT EMITTING DIODES (LEDs) are used to
indicate the chosen cycle, wash temperature, cycle
status and door lock information. Refer below for
information on each LED.
CYCLE LED (NORMAL, PERM PRESS,
DELICATES or SPECIAL WASH)
CYCLE LED will remain lit the entire cycle.
WASH TEMP LED (HOT, WARM or COLD)
WASH TEMP LED will remain on until the end of the
cycle or will change to a rinse temperature if programmed
to do so.
WASH LED
WASH LED is lit at the beginning of a PreWash and
Wash cycle and will remain lit until the wash cycle is
complete.
RINSE LED
RINSE LED is lit at the beginning of the Rinse or
Extra Rinse cycle and will remain lit until the cycle is
complete.
SPIN LED
SPIN LED is lit for all Spin cycles.
CLEAN FILTER (VFD Models Only)
CLEAN FILTER LED is lit when the air filter needs to
be cleaned.
ADD BLEACH
ADD BLEACH LED flashes, if programmed, when
bleach can be added.
INSERT COINS/CARD LED
INSERT COINS/CARD LED prompts the user for
coins or a card to satisfy the vend price. Four digits
and decimal point show the vend price remaining to be
satisfied. The vend price displayed will decrease with
each coin inserted. If a new wash temp is selected
during the first fill of the wash cycle and it requires
additional vend, the INSERT COINS/CARD light will
flash one (1) second on and one (1) second off, and the
display will show the vend price remaining to be
satisfied.
REMOVE CARD LED (Card Models Only)
REMOVE CARD LED flashes one (1) second on and
one (1) second off after the START pad has been
pressed and the vend has been deducted from the card.
It will also flash when a card is inserted and no vend
amount is required.
CLOSE DOOR
CLOSE DOOR LED flashes one (1) second on and
one (1) second off when the control is in the Start
Mode and the door is open. It also flashes in the Ready
Mode with the door open and a card has been inserted.
Whenever the CLOSE DOOR LED flashes, the
START LED is off.
Four 7-Segment Digits
The 7-SEGMENT DIGITS are used to display the
time remaining in a cycle, vend price, error messages
and descriptive codes. When displaying the time
remaining, the colon will flash, and when displaying
the vend price the decimal point may be lit. During
diagnostic testing or manual programming of the
control, these digits will display descriptive codes and
values (as described in Entering the Manual Mode).