Instruction manual

135

F232151

Power Fail Recovery

The Power Fail Recovery feature allows the cycle

status to be saved in memory in the event of a power

failure.

If the power failure lasted less than one minute and

30 seconds, the cycle will resume without requiring

the user to press the START (enter) keypad to restart.

If the control was in a fill cycle step and the pre-

programmed pressure switch is not satisfied, the

control will start the Fill/Tumble step from the

beginning. If the control was in an extract step, the

remainder of the step will be lost and the control will

resume in the next cycle step. However, if the control

was in an extract step prior to the final extract or in the

Final Extract step, the control will resume the cycle

from the beginning of the Previous Drain/Tumble step.

If the power failure lasted longer than one minute and

30 seconds, the Power Fail Reset option is turned ON,

and the duration of the power failure is less than or

equal to the time programmed in the Power Fail Reset

option, or the Power Fail Reset option is turned off, the

START (enter) keypad will flash until it is pressed and

the cycle will restart from the point it left off. Extract

steps are the same as previous paragraph.

If the power failure lasted longer than one minute and

30 seconds, lasted longer than the time programmed in

the Power Fail Reset option, and the Power Fail Reset

option is turned ON, the control will return to the

Ready Mode. The door will remain locked for one

minute.