Instruction manual

129
F232151
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Rapid Advance Feature
The Rapid Advance feature allows the owner to
quickly advance through active cycles or advance into
a cycle from the Ready Mode.
How to Enter Rapid Advance from
Ready Mode
1. If control is in Ready Mode, control must be put
into Manual Mode. Refer to Entering the
Manual Mode.
2. Press the DELICATES (+) or the COLD (-)
keypad until “rAPd” appears in the display.
3. Press the START (enter) keypad. The VFD will
display cycle time and the START (enter) keypad
LED will flash.
4. Press the START (enter) keypad to start cycle.
How to Enter Rapid Advance During
an Active Cycle
1. Be certain access panel is open.
2. While pressing and holding the NORMAL
keypad with one hand, press the HOT keypad
with the other hand. There will be no change on
the VFD display.
Control may be in an active cycle or in the Ready
Mode to use the Rapid Advance feature.
While in the Rapid Advance Mode, pressing the
START (enter) keypad will advance the washer-
extractor to the next cycle step. The cycle indicator
lights will tell which cycle step the washer-extractor is
in.
For Example: If the washer-extractor is in the first fill
cycle step, pressing the START (enter) keypad will
advance the washer-extractor into the first drain cycle.
Continue pressing the START (enter) keypad until the
cycle is completed.
How to Exit Rapid Advance Feature
1. Advance through the cycles until reaching the
shakeout cycle step with one minute cycle time
remaining.
NOTE: The Rapid Advance option must be turned
on for Rapid Advance to work. Refer to option 83 in
Programming NetMaster in the Enhanced
Programming Guide, available at extra cost.
NOTE: When Rapid Advance is used to end a
cycle, the cycle may be advanced to, but not
beyond, the shakeout step which must then execute
normally and provides a one minute delay before
the door will be unlocked.