Instruction manual

F232151

NetMaster Identification

Select Cycle Pads

(Refer to Figure 1)

SELECT CYCLE pads are used to select the specific

washer-extractor cycle. These pads include

NORMAL, PERM PRESS, DELICATES and

SPECIAL WASH. These pads allow the user to select

a cycle other than the default cycle (PERM PRESS).

The SELECT CYCLE keypads are not active after the

first fill cycle of the washer-extractor. The selected

cycle is indicated by the light (LED) on the pad.

Pressing the START pad will confirm the selection and

the cycle will begin. When the Smart Card is used, the

START pad flashes. Pressing the START pad will start

the cycle and deduct the vend price from the card.

Select Wash Temp Pads

(Refer to Figure 1)

SELECT WASH TEMP pads are used to select the

temperature of the water used for the wash fill/tumble.

These pads include HOT, WARM and COLD. These

pads allow the user to select a water temperature other

than the default setting (WARM). The SELECT

WASH TEMP pads are active only during the first fill/

tumble cycle of the washer. The selected temperature

is indicated by the light (LED) on the pad.

Both the SELECT WASH TEMP pads and the SELECT

CYCLE pads are used in various combinations for

programming cycles, retrieving audit information,

running diagnostic tests and other hidden operations.

These instructions cover the basic manual

programming and data retrieval options.

Figure 1

C872I

1 LED Light 5 VFD Display

2 LED Status Lights 6 START pad

3 SELECT CYCLE pads (top row) 7 SELECT WASH TEMP pads (bottom row)

4 Four 7-Segment Digits

C872I

ELECTRONIC DISPLAY CONTROL