Instruction manual

Programming NetMaster
101
F232151
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
119. Auto-Flush Hour “+119”
This option allows the owner to set the hour that the
dispensers will automatically flush.
NOTE: The loading door must be closed and
latched for Auto-Flush to occur.
How to Program Auto-Flush Hour
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the DELICATES (+) or the COLD (-)
keypad until “PrOg” appears in the VFD. Press
the START (enter) keypad and “+001” will
appear in the VFD.
Figure 192
3. Press the DELICATES (+) or the COLD (-)
keypad to scroll through the programmable
options until “+119” appears in the VFD. Refer
to Figure 193.
Figure 193
4. When “+119” appears in the VFD, press the
START (enter) keypad. The current start time (in
military time) will appear in the VFD.
5. Press the DELICATES (+) or the COLD (-)
keypad to increase or decrease the current hour to
the desired hour. Refer to Figure 194.
Figure 194
6. Press the START (enter) keypad when the correct
hour appears in the VFD. The next option,
“+120”, will appear in the VFD.
NOTE: For Auto-Flush to work at the hour
selected, the Auto-Flush option must be turned on
and the number of cycles between flushes must be
selected. Refer to option 118.
NOTE: To program “+120” (Auto-Flush DOW),
refer to option 120. To program other options, refer
to the appropriate section.
How to Exit Programming Feature
1. Be sure the control shows a programmable
option, not a value.
2. While pressing and holding the NORMAL
keypad with one hand, press the PERM PRESS
keypad with the other hand. The control will
revert back to the Ready Mode. Refer to
Figure 2.
C762I
CHM14R
B029R
1 Press this pad (+) to scroll forward or increase a value
2 Press this pad (enter) to choose a selected value or
option
3 Press this pad (-) to scroll back or decrease a value
neednew#2
1
32