Instruction manual

Programming NetMaster
91
F232151
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
74. Special Wash Rinse Final
Fill/Tumble Time “+074”
This option allows the owner to set the amount of time
for a final rinse fill/tumble in the Special Wash cycle.
How to Program Special Wash Rinse Final
Fill/Tumble Time
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the DELICATES (+) or the COLD (-)
keypad until “PrOg” appears in the VFD. Press
the START (enter) keypad and “+001” will
appear in the VFD.
Figure 177
3. Press the DELICATES (+) or the COLD (-)
keypad to scroll through the programmable
options until “+074” appears in the VFD. Refer
to Figure 178.
Figure 178
4. When “+074” appears in the VFD, press the
START (enter) keypad. The current number
of minutes set for the Special Wash Rinse Final
Fill/Tumble Time will appear in the VFD.
5. Press the DELICATES (+) or the COLD (-)
keypad to increase or decrease the current
number of minutes displayed in the VFD to the
desired number of minutes. Refer to Figure 179.
NOTE: The Special Wash Rinse Final Fill/Tumble
Time can be set from zero (0) to 15 minutes.
Figure 179
6. Press the START (enter) keypad when the correct
number of minutes appears in the VFD. The next
option, “+075”, will appear in the VFD.
NOTE: To program “+075” (Special Wash Spin
Extract Time), refer to option 75. To program other
options, refer to the appropriate section.
How to Exit Programming Feature
1. Be sure the control shows a programmable option,
not a value.
2. While pressing and holding the NORMAL
keypad with one hand, press the PERM PRESS
keypad with the other hand. The control will
revert back to the Ready Mode. Refer to
Figure 2.
C762I
CHM10R
B029R
1 Press this pad (+) to scroll forward or increase a value
2 Press this pad (enter) to choose a selected value or
option
3 Press this pad (-) to scroll back or decrease a value
neednew#2
1
32