Instruction manual

Programming NetMaster
47
F232151
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
21. Special Vend A End Date “+021”
This option allows the owner to set the date that
Special Vend A will end.
How to Program Special Vend A End Date
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the DELICATES (+) or the COLD (-)
keypad until “PrOg” appears in the VFD. Press
the START (enter) keypad and “+001” will
appear in the VFD.
Figure 56
3. Press the DELICATES (+) or the COLD (-)
keypad to scroll through the programmable
options until “+021” appears in the VFD. Refer
to Figure 57.
Figure 57
4. When “+021” appears in the VFD, press the
START (enter) keypad. The current end date will
appear in the VFD.
5. Press the DELICATES (+) or the COLD (-)
keypad to increase or decrease the end date to the
desired date. Refer to Figure 58.
If “0” is selected and Special Vend A is on,
Special Vend A will occur at the time or days of
week selected, regardless of the date.
Figure 58
6. Press the START (enter) keypad when the correct
date appears in the VFD. The next option, “+022”,
will appear in the VFD.
NOTE: To program “+022” (Special Vend A Site
Code #1), refer to option 22 in Programming
NetMaster in the Enhanced Programming Guide,
available at extra cost. To program other options,
refer to the appropriate section.
How to Exit Programming Feature
1. Be sure the control shows a programmable option,
not a value.
2. While pressing and holding the NORMAL
keypad with one hand, press the PERM PRESS
keypad with the other hand. The control will
revert back to the Ready Mode. Refer to
Figure 2.
C762I
C791I
B029R
1 Press this pad (+) to scroll forward or increase a value
2 Press this pad (enter) to choose a selected value or
option
3 Press this pad (-) to scroll back or decrease a value
neednew#2
1
32