Instruction manual

109

F232151

Manual Reset

This feature allows the owner to reset the washer-

extractor control’s programming data to the factory

default settings by pressing a sequence of pads on the

control. For an explanation of the Factory Default

Settings, refer to Default Washer-Extractor Settings.

How to Enter Manual Reset

1. Control must be in Manual Mode to start.

Refer to Entering the Manual Mode.

2. Press the DELICATES (+) or the COLD (-)

keypad until “rSET” appears. Refer to

Figure 205.

Figure 205

3. Press the START (enter) keypad. The control will

display “WAIT” until the programming is

complete. Once the program has been reset, the

control will revert back to the Ready Mode.

C830I