Service manual

39201 79

To reduce the risk of electric shock, fire, explosion, serious injury or death:

• Disconnect electric power to the washer before servicing.

• Never start the washer with any guards/panels removed.

• Whenever ground wires are removed during servicing, these ground wires must be

reconnected to ensure that the washer is properly grounded.

W003

WARNING

Section 6

Adjustments

44. LEVELING LEGS

Refer to Figure 62

a. Place rubber feet on all four leveling legs.

b. Place washer in position on a clean, dry, and

reasonably firm floor.

c. Loosen locknuts and adjust two front leveling

legs. Once adjusted, tilt washer forward on

front legs and lower back down into position to

set the rear self-leveling legs.

d. Washer must not rock. After washer is at

desired height, tighten locknuts securely

against bottom of washer base. If these locknuts

are not tight, washer will not remain stationary

during operation.

NOTE: Install rear extension leg kit, No. 566P3,

(optional equipment at extra cost) to raise height of

washer.

NOTE: Improper installation, installation on carpet

or flexing of a weak floor will cause excessive

vibration.

IMPORTANT: Do not slide washer across floor

once leveling legs have been extended, as legs and

base could become damaged.

Figure 62

W484SE3A

RUBBER

FOOT

LEVELING

LEG

LOCKNUT

WASHER

BASE

LEVEL