Service manual

62 39201
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
W003
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
IMPORTANT: When installing module springs,
make sure spring hook is fully seated in hole and in
formed depression in tub skirt.
r. Loosen hose clamp and remove drain hose from
pump outlet. Refer to Figure 53.
s. Loosen hose clamp and remove pressure hose
from pressure bulb.
t. Remove wire tie holding motor wire harness to
support leg.
u. Grasp outer tub and lift complete tub module
assembly straight up and out of washer cabinet.
v. Turn outer tub upside-down and set on
protective padding.
w. Remove motor and mounting bracket. Refer to
Paragraph 30.
x. Remove screws and lockwashers holding
counterweight and each support leg to outer
tub. Refer to Figure 54. Then lift transmission,
weldment assembly and counterweight off tub.
y. Loosen hose clamp and remove tub-to-pump
hose, from bottom of outer tub. Refer to
Figure 53.
NOTE: To prevent porcelain damage, leg plates
must be installed on outside of outer tub flange
when reinstalling support legs of weldment
assembly. Do not overtighten screws as this could
cause stripping or porcelain damage. Torque
screws between 90 to 130 inch-pounds (10.30 to
14.87 N-M).
z. Turn outer tub upright and remove pressure
bulb and grommet.
NOTE: When installing grommet into outer tub,
thicker lip of grommet must be installed to outside
of tub. Lubricate outer surface of large opening of
pressure bulb with liquid soap to aid when
assembling pressure bulb into grommet.
IMPORTANT: When reinstalling complete tub
module, carefully set the tub module pivot dome on
top of friction ring. DO NOT ALLOW TUB
MODULE TO BE DROPPED OR LOWERED
INTO POSITION TOO HARD! This can
damage or crack the friction ring.
39. DRIVE PULLEY, HELIX AND BRAKE
a. Open loading door.
b. Remove agitator by placing two agitator hooks,
No. 254P4P, under bottom edge of agitator.
Refer to Figure 29.
IMPORTANT: Hooks should be positioned 180
degrees from each other, and must be placed under
agitator vane for greater stability. If hooks are
placed between vane area, agitator damage may
occur.
c. Using a rocking motion (back and forth)
carefully lift agitator off drive bell.
d. Remove two screws from bottom edge of front
panel. Refer to Figure 37.
e. Pull bottom of panel away from washer until
hold down clips (located on top flange of panel)
disengage from slots in cabinet top.
f. METERED MODELS:
(1) Unlock and remove meter case service
door.
Figure 53
W482SE1C
MODULE
SPRINGS
TUB-TO-PUMP
HOSE
HOLES
TUB
SKIRT
DRAIN
HOSE