Service manual

39201 59
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
W003
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
l. To install No. 39122 Gasket, follow these steps:
(1) Thoroughly clean all foreign material from
seal surface area of hub and bronze bearing.
(2) Apply a small amount of nonstaining
petroleum jelly (such as Vaseline®) to both
surfaces where gasket will contact hub
assembly and bottom of washtub.
(3) Carefully place No. 39122 Gasket
(supplied in kit) on hub assembly.
NOTE: Ensure holes in gasket are aligned with
holes in hub assembly and all traces of original
washtub gasket are removed from bottom of
washtub.
m. Grasp top flange of washtub and carefully
lower washtub down onto gasket and hub
assembly.
IMPORTANT: Before setting washtub into place,
make sure holes in hub assembly are aligned with
holes in gasket.
n. Secure washtub to hub assembly, using cap
screws and gaskets from 27202P Screw and
Gasket Kit (supplied in kit).
NOTE: Gaskets are used on models equipped with
a porcelain washtub.
IMPORTANT: Porcelain Washtub Models — Use
care when tightening cap screws to avoid chipping
or damaging porcelain finish.
o. Install No. 38359 Tub Cover Gasket (supplied
in kit) into outer tub cover. Refer to Paragraph
36.
IMPORTANT: When installing outer tub cover
always use a new tub cover gasket.
p. Reassemble washtub, Paragraph 36.
q. Install seal, drive bell and agitator following the
instructions supplied in No. 39508P Drive Bell
and Seal Kit.
r. Reinstall cabinet top and front panel.
s. Close loading door, set washer timer to final
spin, start washer and allow empty washtub to
spin for 30 seconds.
Figure 52
W180SE3B
STAINLESS STEEL
SLEEVE
LUBRICATE
(Step “c”)
BRONZE PORTION
OF SEAL
FLUSH
GARTER
SPRING
APPLY BEAD OF
NO. 27615P
SEALANT (3M800) HERE
(Step “f”)
INSERT STAINLESS STEEL
SLEEVE FROM BOTTOM SIDE OF SEAL
APPLY BEAD OF
NO. 27615P
SEALANT (3M800) HERE
(Step “f”)
GARTER
SPRING
PRESS HERE
TO ASSEMBLE
WATER
SEAL
LUBRICATE
(Step “c”)