Service manual

58 39201
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
W003
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
INSTALLING NO. 646P3 HUB AND SEAL
KIT
a. Thoroughly clean all foreign material from
inner surface of outer tub flange.
IMPORTANT: All foreign material must be
removed from inner surface of outer tub flange
before installing No. 646P3 Hub and Seal Kit.
b. Apply a small amount of No. 27615P Sealant
(3M800) around outer surface of tub flange.
Refer to Figure 51. Obtain sealant from local
parts distributor.
c. Apply a light film of nonstaining petroleum
jelly (such as Vaseline®) to bronze portion of
water seal and to outer surface of stainless steel
sleeve. Refer to Figure 52.
IMPORTANT: DO NOT over lubricate!
d. Insert stainless steel sleeve into water seal from
bottom of water seal, Refer to Figure 52, until
stainless steel sleeve is flush with bronze
portion of water seal.
e. Leaving garter spring on water seal, place new
water seal over outer tub flange (with seal lip on
outside of tub flange). Then press seal into tub
flange opening using moderate finger pressure.
f. Carefully apply a small amount of No. 27615P
Sealant (3M800) around outer edge of water
seal and tub (area located just below garter
spring). Refer to Figure 52. Obtain sealant from
local parts distributor.
IMPORTANT: DO NOT allow sealant to contact
sealing surface of water seal because it will cause a
water leak.
g. Lubricate inner splines of new hub assembly
(supplied in kit) with No. 27604P Anti-Seeze
Compound.
h. Carefully place new hub assembly on splined
transmission tube.
IMPORTANT: Firmly push hub assembly down
against outer tub seal and hold in this position
during the next three steps.
i. While holding down hub assembly, place new
spline insert (with fingers pointing upward)
over transmission tube until it bottoms out on
hub assembly.
j. Place large hex nut over transmission tube
(with larger inside bevel toward spline insert)
then finger tighten large hex nut.
k. Torque large hex nut between 40 to 70 foot-
pounds (5.56 to 13.21 Kgm).
NOTE: If torque wrench is not available, place No.
306P4 Hex Wrench over large hex nut then tap hex
wrench with a hammer until hub assembly turns or
until large hex nut will no longer tighten.
Figure 51
APPLY BEAD
OF NO. 27615P
SEALANT
(Step “b”)
W445SE1A
OUTER
TUB FLANGE