Service manual

39201 49
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
W003
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
33. IDLER LEVER AND PULLEY
a. Remove two screws from bottom edge of front
panel. Refer to Figure 37.
b. Pull bottom of panel away from washer until
hold down clips (located on top flange of panel)
disengage from slots in cabinet top.
IMPORTANT: There will always be some water
that will remain in outer tub, therefore, before
removing hoses from pump, hoses must be pinched
off or drained to prevent water spillage.
c. Loosen hose clamps and remove hoses from
pump assembly. Refer to Figure 43.
d. Unhook idler spring from idler lever.
Refer to Figure 43.
IMPORTANT: Use care when removing idler
spring. If idler spring is overstretched, washer
operation will be affected.
e. Reach in and around right side of motor and run
belt off right side of large drive pulley.
Refer to Figure 43.
f. Disconnect wire harness from motor switch by
pressing down on locking tab on top of
connection block and at the same time pull
connection block away from motor switch.
Refer to Figure 43.
g. Remove four screws holding motor mounting
bracket to lower flange of outer tub and to
weldment assembly. Refer to Figure 43. Then
remove complete assembly out of washer.
NOTE: For ease of idler lever removal, remove
pump assembly from motor, then remove motor
from mounting bracket.
h. Remove nut, washer and bolt holding idler
lever and pulley to motor mounting bracket.
Refer to Figure 42.
NOTE: Refer to Figure 42 for idler lever and pulley
assembly sequence.
i. Apply a light film of No. 03200 Lubricant to
area of idler lever that makes contact with
motor mounting bracket.
Figure 43
W476SE3B
PUMP
HOSES
MOTOR
SWITCH
IDLER
SPRING
CONNECTION
BLOCK
LOCKING
TAB
SWITCH
ATTACHING
SCREW
MOTOR
MOUNT
ATTACHING
SCREWS
BELT
SHIELD
ATTACHING
SCREW