Service manual

44 39201
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
W003
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
30. MOTOR AND MOUNTING BRACKET
a. Remove two screws from bottom edge of front
panel. Refer to Figure 37.
b. Pull bottom of panel away from washer until
hold down clips (located on top flange of panel)
disengage from slots in cabinet top.
IMPORTANT: There will always be some water
that will remain in outer tub, therefore, before
removing hoses from pump, hoses must be pinched
off or drained to prevent water spillage.
c. Loosen hose clamps and remove hoses from
pump assembly. Refer to Figure 40.
d. Unhook idler spring from tab on front of motor
mounting bracket. Refer to Figure 40.
IMPORTANT: Use care when releasing idler lever
tension. If idler spring is overstretched, washer
operation will be affected.
e. Reach in and around right side of motor and run
belt off right side of large drive pulley. Refer to
Figure 40.
f. Disconnect wire harness from motor switch by
pressing down on locking tab on top of
connection block and at the same time pull
connection block away from motor switch.
Refer to Figure 40.
g. Remove four screws holding motor and
mounting bracket to lower outer tub flange and
to weldment assembly. Refer to Figure 40.
Then lift complete assembly out of washer.
IMPORTANT: Carefully lay motor on its side.
Observe belt configuration around rear pump leg.
Belt MUST encircle rear pump leg when
reassembling. Refer to Figure 41.
Figure 40
W476SE3C
PUMP
HOSES
MOTOR
SWITCH
IDLER
SPRING
CONNECTION
BLOCK
LOCKING
TAB
SWITCH
ATTACHING
SCREW
MOTOR
MOUNT
ATTACHING
SCREWS
BELT
TAB