Service manual

28 39201

Section 5 Service Procedures

To reduce the risk of electric shock, fire, explosion, serious injury or death:

• Disconnect electric power to the washer before servicing.

• Never start the washer with any guards/panels removed.

• Whenever ground wires are removed during servicing, these ground wires must be

reconnected to ensure that the washer is properly grounded.

W003

WARNING

f. DUAL COIN DROP REMOVAL

(1) Unlock and open service door.

NOTE: If screw type lock is used, the retainer

bracket must be removed from inside meter case.

(2) Disconnect wire harness from coin drawer

switch and disconnect coin drops at

disconnect plugs.

(3) Press in on locking tabs of service door

switch and remove switch from bracket on

meter case, as shown in Figure 15.

(4) Remove wire harness from multiplier.

Refer to Figure 16. Move wire harness out

of the way.

(5) Remove multiplier from inside meter case.

Refer to Figure 16.

NOTE: Multiplier is held inside meter case by two

Velcro strips.

Figure 15

W408SE3A

SERVICE DOOR

SWITCH

BRACKET

METER

CASE