Service manual

22 39201
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
W003
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
b. CYCLE SELECTOR OR WASH
TEMPERATURE SWITCH:
(1) Remove two control panel attaching
screws. Refer to Figure 5. Lay assembly
forward on protective pad on cabinet top.
(2) Loosen setscrew holding switch knob to
switch shaft. Refer to Figure 7.
(3) Remove knurled nut holding switch to
control panel. Refer to Figure 7.
NOTE: Lockwasher must be between switch and
control panel when installing switch. Refer to
Figure 7.
(4) Disconnect wires from switch.
NOTE: Refer to appropriate wiring diagram when
rewiring switch.
c. INDICATOR LIGHTS
(In Use, Rinse or Spin. Refer to Figure 6):
(1) Remove two control panel attaching
screws. Refer to Figure 5. Lay assembly
forward on protective pad on cabinet top.
(2) Disconnect wires from light.
NOTE: Refer to wiring diagram when rewiring
light.
(3) Squeeze locking tabs together and pull light
out rear of control panel.
d. PRESSURE SWITCH
(1) Remove two control panel attaching
screws. Refer to Figure 5. Lay assembly
forward on protective pad on cabinet top.
(2) Remove two screws holding switch to
cabinet top. Refer to Figure 6.
(3) Pull switch out of control hood far enough
to disconnect pressure hose and wires from
switch.
NOTE: Refer to appropriate wiring diagram when
rewiring pressure switch.
IMPORTANT: When installing pressure switch,
blow air into hose before connecting hose to switch
to remove any moisture that may have accumulated
in hose.
Figure 7
W492SE1A
LOCKWASHERS
PANEL
SCREW
WASH
TEMPERATURE
SWITCH
CYCLE
SELECTOR
SWITCH
SETSCREW
KNURLED
NUT
KNOB