Specifications

PHM553N_SVG

IMPORTANT: Do not attach anything to nozzles. Air gap must be maintained.

Five Compartment Supply Dispenser (Optional)

1. Strain Relief for Liquid Chemical Supply Lines

2. Supply Dispenser Lid

3. Nozzles

4. Dry Supply Cups

5. Dry Supply Insert

6. Polypropylene Supply Dispenser

Figure 24

1. Remove knockout from supply dispenser. Refer to Figure 24 .

Plugs are assembled inside the tubing ring.

2. Install PG connector in hole with strain reliefs, included in the

seal nut.

3. Insert tubes through PG base. Do not remove cups. Tube

should extend into the plastic cup, with the exception of the

softener tube, which should be routed to the outside of the

cup.

4. Tighten the seal nut to prevent tubing from escaping the as-

sembly.

5. Before operating machine, confirm lid is completely closed.

Specifications and Dimensions

F8423301ENR3