Specifications

WARNING

To prevent personal injury, avoid contact with inlet

water temperatures higher than 125° Fahrenheit [51°

Celsius] and hot surfaces.

W748

Maximum water inlet temperature is 190 °Fahrenheit [ 88 °Cel-

sius].

Water Supply Information

Specifications 35 60 80/100 125/150

Number of main fill water inlets 2 2 2 2

Main fill water inlet size at machine, in.

[mm]

3/4 3/4 3/4 1

Factory supplied

hose

Size 19 19 19 25.4

Thread 11.5 11.5 11.5 56

Number of spray rinse water inlets 2 2 2 2

Spray rinse water inlet size, in. [mm] 3/4 [19] 3/4 [19] 3/4 [19] 3/4 [19]

Recommended pressure psi [bar] 30–8 [52–5.7 ]

Inlet flow capacity, gal/min [l/min] at

80 psi

28 [106] 39 [148] 50 [189] 75 [284]

Table 15

To connect water service to machine with rubber hoses, use the

following procedure:

1. Before installing hoses, flush the water system for at least two

minutes.

2. Check filters in the machine’s inlet hoses for proper fit and

cleanliness before connecting.

3. Hang the hoses in a large loop; do not allow them to kink.

If additional hose lengths are needed or using hoses other than

those supplied by manufacturer, flexible hoses with screen filters

are required.

Lower pressures will increase fill times.

Suitable air cushions [risers] should be installed in supply lines to

prevent “hammering.” Refer to Figure 17 .

Connect machine to a backflow preventer (vacuum breaker) be-

fore connecting to the public water main in all countries where

local regulations require specific water approval certificates.

Specifications and Dimensions