Specifications

ManualsBrandsAlliance Laundry Systems ManualsDomestic AppliancesGA2210*A1102

Floor Load Data

Specifica-

tions Speed 35 60 80 100 125 150

Dynamic

load fre-

quency, Hz

V-speed 15 13.6 12.8 12.8 9.7 11.7

2-speed 8.2 8.0 N/A N/A N/A N/A

L-speed 8.63 7.82 N/A N/A N/A N/A

M-speed 11.58 10.5 9.9 9.9 9.2 N/A

Maximum

vertical

load,

V-speed 2,848 [12.7] 4,146 [18.4] 5,895 [26.2] 6,994 [31.1] 7,028 [31.3] 8,437

[37.52]

2-speed 1,745 [7.8] 2,392 [10.6] N/A N/A N/A N/A

L-speed 1,797 [8] 2,342

[10.4 ]

N/A N/A N/A N/A

M-speed 2,216 [9.9] 3,066 [13.6] 4,459 [19.8] 5,198 [23] 6,663 [29.6] N/A

Base mo-

ment, lbs.-ft

[kN-m]

V-speed 4,076 [5.54] 8,492 [11.5] 11,688

[15.9]

14,611

[19.9]

12,488 [17] 17,231

[23.4]

2-speed 1,224 [1.7] 2,985 [4] N/A N/A N/A N/A

L-speed 1,356 [1.8] 2,826 [3.8] N/A N/A N/A N/A

M-speed 2,442 [3.3] 5,099 [6.9] 7,029 [9.6] 8,786 [11.9] 11,268

[15.3]

N/A

N/A = Not Applicable

Acting in the downward direction against the floor.

Table 4

Mounting Bolt Installation Require-

ments [Approved Foundations Only]

NOTE: If installing epoxy bolts into an elevated con-

crete foundation pad, the concrete foundation pad

should extend a minimum of 9 inches [229 mm] (for 35

pound machines or 12 inches [305 mm] for 60-150

pound machines out from the machine base on all

sides. Refer to Figure 4 .)

A bolt kit consisting of eight bolts is available as an option. 35

machines use 5/8-11 x 8 inch bolts. 60-125 machines use 3/4-10

x 8 inch bolts. 150 machines use 3/4-10 x10 inch grade 5 bolts.

The bolts should be embedded in a 4,000 psi [ 241 bar] minimum

reinforced concrete floor that is a minimum of 6 inches [152 mm]

[for 35 and 60 2-speed, L-speed, and M-speed models] or a 12 in-

ches [305 mm] [for all other models] thick. Use the mounting

bolt layouts in Mounting Bolt Hole Locations section.

On 35–125 machines, the threaded end of the bolts should extend

2 inches [51 mm] above the mounting surface. On 150 machines,

Specifications and Dimensions