Specifications

ManualsBrandsAlliance Laundry Systems ManualsCordless TelephoneFLW1527C

Installation

803528

Step 6: Remove the Shock Sleeves and

Shipping Brace

Remove front access panel by removing the two screws

at the bottom of the panel.

Remove the five bolts and lockwashers from shipping

brace with 9/16 in. wrench and remove brace. Refer to

Figure 10. Four bolts are located on the washer base.

One is holding the brace to the weight. Remove this

bolt first. Remove the two front bolts next and then the

two rear bolts. Remove all four shock sleeves by

pulling on the yellow rope. Remove label from front

side of front access panel or shipping brace and place

on backside of front access panel for future reference.

NOTE: The shipping brace, bolts, washers and

shock sleeves should be saved and MUST be

reinstalled whenever the washer is moved more

than four feet. Refer to User-Maintenance section

for instructions. Do not lift or transport washer

from front or without shipping materials installed.

Store the shipping materials in the accessories bag.

Save materials for use whenever the washer is moved.

Reinstall front access panel.

IMPORTANT: DO NOT tip washer more than

152.4 mm (6 inches) in any direction after shipping

brace has been removed. Shock absorbers may

separate and damage to washer may result. For

leveling purposes, the washer may be tilted a

maximum of 152.4 mm (6 inches) in any direction.

Figure 10

Step 7: Wipe Out Inside of Wash Drum

Before using washer for the first time, use an all-purpose

cleaner, or a detergent and water solution, and a damp

cloth to remove shipping dust from inside wash drum.

Figure 11

Step 8: Plug In the Washer

Electrical Requirements

(120 Volt, 60 Hertz with 3-Prong Grounding Plug)

NOTE: The wiring diagram is located in the

control cabinet.

When plugging in the washer:

 DO NOT overload circuits.

 DO NOT use an extension cord.

 DO NOT use an adapter.

 DO NOT operate other appliances on the same

circuit. Use separately fused 15 Amp circuits.

FLW2124N

1 Shock Sleeves

2 Motor Mount

3 Hooked End of Shipping Brace

4 Bolts and Lockwashers

FLW2124N

FLW2115N

To reduce the risk of fire, electric shock,

serious injury or death, all wiring and

grounding MUST conform with the latest

edition of the National Electrical Code,

ANSI/NFPA No. 70, and such local

regulations as might apply. It is the

customer’s responsibility to have the

wiring, fuses and circuit breakers

installed by a qualified electrician to make

sure adequate electrical power is

available to the washer.

W518

WARNING