Service manual

70 505894

Section 7 Test Procedures

To reduce the risk of electric shock, fire, explosion, serious injury or death:

• Disconnect electric power to the dryer(s) before servicing.

• Close gas shut-off valve to gas dryer(s) before servicing.

• Never start the dryer(s) with any guards/panels removed.

• Whenever ground wires are removed during servicing, these ground wires must be

reconnected to ensure that the dryer is properly grounded.

W001R1

WARNING

NOTE: Timer Motor Resistance:

120 Volt, 60 Hz 2,460 – 3,100 Ohms

240 Volt 10,900 – 13,000 Ohms

24 Volt 80 – 130 Ohms

(4) Rotate timer to “cooldown” (5 minutes

before “OFF”). “Infinite” (open) reading

should be found between L2 and H.

(5) Rotate timer to “OFF” position. “Infinite”

(open) reading should be found between L1

and M and between L2 and H.

NOTE: Timer motor power is supplied through M

(1702 and1709 models) or N (all other models)

terminal.

65. FABRIC SELECTOR SWITCH

NOTE: Refer to proper model wiring diagram

when rewiring switch.

a. Set test meter to read Ohms and apply meter

probes to switch terminals.

NOTE: Refer to proper model wiring diagram

when reconnecting wires.

FABRIC SELECTOR SWITCH – 4 Position

L1-1 L1-2

No Heat/Air Fluff – –

Delicate X X

Perm. Press – X

Regular – X

X indicates closed

FABRIC SELECTOR SWITCH

– 3 Position

L1-2 L1-3 L1-1

No Heat/Air Fluff – X –

Delicate/Knits X – X

Regular/Perm. Press X – –

X indicates closed