Service manual

56 505894

Section 5 Service Procedures

To reduce the risk of electric shock, fire, explosion, serious injury or death:

• Disconnect electric power to the dryer(s) before servicing.

• Close gas shut-off valve to gas dryer(s) before servicing.

• Never start the dryer(s) with any guards/panels removed.

• Whenever ground wires are removed during servicing, these ground wires must be

reconnected to ensure that the dryer is properly grounded.

W001R1

WARNING

(8) Remove two screws holding shroud to

heater duct, and remove shroud out through

front of dryer. Refer to Figure 19.

j. Electric Models:

(1) Remove two screws holding element and

plate to heater box, then pull element down

and away from heater box. Refer to

Figure 21.

(2) Remove all wires from terminal block.

NOTE: Refer to appropriate wiring diagram when

rewiring terminal block.

(3) Remove screw holding terminal block to

rear bulkhead. Refer to Figure 38.

k. While supporting bulkhead, remove the four

screws holding rear bulkhead to dryer cabinet,

then lift complete assembly out of dryer. Refer

to Figure 35.

l. Remove heater duct from rear bulkhead. Refer

to Figure 37.

Figure 37

Heater

Duct

Attaching

Screws

Heater

Duct

Attaching

Screws

Heater

Duct

Rear

Bulkhead

D261SE3B