Service manual

38 505894

Section 5 Service Procedures

To reduce the risk of electric shock, fire, explosion, serious injury or death:

• Disconnect electric power to the dryer(s) before servicing.

• Close gas shut-off valve to gas dryer(s) before servicing.

• Never start the dryer(s) with any guards/panels removed.

• Whenever ground wires are removed during servicing, these ground wires must be

reconnected to ensure that the dryer is properly grounded.

W001R1

WARNING

41. CYLINDER LIGHT

Refer to Figure 17.

a. Open loading door and remove screw holding

lens to front bulkhead.

b. Turn bulb counterclockwise and twist out of

light receptacle.

42. CYLINDER LIGHT RECEPTACLE

Refer to Figure 17.

a. While supporting the access panel, remove two

screws from bottom edge of access panel. Refer

to Figure 7.

b. Gently lower access panel to disengage panel

locators from bottom edge of front panel. Refer

to Figure 16.

c. Remove two screws holding bottom tabs on

front panel to dryer side panels. Refer to

Figure 8. Swing bottom of front panel away

from dryer far enough to disengage hold-down

clips and locators from cabinet top.

d. Disconnect wires from door switch. Refer to

Figure 15.

NOTE: Refer to wiring diagram when rewiring

switch.

e. Remove screw holding lens to front bulkhead.

f. Disconnect wires from light receptacle

terminals.

NOTE: Refer to wiring diagram when rewiring

receptacle terminals.

g. Unsnap and lift light receptacle out of front

bulkhead.

Figure 17

DRY1821S