Specifications

Installation

Before You Start

Tools

For most installations, the basic tools you will need are:

Exhaust

Use rigid metal duct and exhaust the dryer to the

outside by the shortest route possible.

1 Wrench

2 Screwdrivers

3 Level

4 Teflon Tape

5 Duct Tape

q ......

D8181

Figure 1

Gas

Dryer is equipped for Natural Gas with a 0.375 inch

NPT gas supply connection. For more detailed

information, refer to section on Gas Requirements.

Location

Place the dryer on a solid floor with an adequate air

supply. For more detailed information, refer to section

on Location Requirements.

WARNING

Any disassembly requiring the use of

tools must be performed by a suitably

qualified service person.

W299

//i"/////////////, U/l,

DRY686N

Figure 2

NOTE: For more detailed information, refer to

section on Dryer Exhaust Requirements.

Electrical

ELECTRIC DRYER

Dryer needs a 4 wire 120/240 Volt, 30 Amp, 60 Hertz,

1 Phase electrical supply.

GAS DRYER

Dryer needs a 120 Volt, 15 Amp, 60 Hertz, polarized

3 slot effectively grounded receptacle.

NOTE: For more detailed information, refer to

section on Electrical Requirements.

If the supply cord is damaged, it must be replaced by a

special cord or assembly available from the

manufacturer or its service agent and is to be replaced

by a qualified service person.