Specifications

ManualsBrandsAlliance Laundry Systems ManualsWashersDRY683C

Installation

Exhaust System

IMPORTANT: Keep exhaust duct as short as

possible.

NOTE: Be certain old ducts are cleaned before

installing your new dryel.

For best drying results, recommended maximum

length of exhaust system is shown in Table 2.

To prevent backdraft when dryer is not in operation,

outer end of exhaust pipe must have a weather hood

with hinged dampers (obtain locally).

NOTE: Weather hood should be installed at least

12 inches (30.5 cm) above the ground. Larger

clearances may be necessary in areas where heavy

snowfall can occm.

Exhaust Direction

The dryer can be exhausted to the outdoors through the

back, left, right or bottom of the dryer. EXCEPTION:

Gas dryers cannot be vented out the left side

because of the burner housing.

Dryer is shipped from factory ready for rear exhaust;

no kits required.

Exhausting the dryer through sides or bottom can be

accomplished by installing a DK1 Sales Accessory

(Directional Exhaust Kit 528P3) available as optional

equipment at extra cost.

528P3 DIRECTIONAL EXHAUST KIT

Figure 21

D3711

Number of Weather Hood Type

90 ° Elbows Recommended Use only for short run installations

4 in. "_

(10.2 cm) (10.2 cm)

D6731 2.5 in.

(6.35 cm)

Maximum length of 4 in. (10.2 cm) diameter rigid metal duct

0 65 feet (19.8 m) 55 feet (16.8 m)

1 55 feet (16.8 m) 47 feet (14.3 m)

2 47 feet (14.3 m) 41 feet (12.5 m)

3 36 feet (11.0 m) 30 feet (9.1 m)

4 28 feet (8.5 m) 22 feet (6.7 m)

Maximum length of 4 in. (10.2 cm) diameter flexible metal duct

0 45 feet (13.7 m) 35 feet (10.7 m)

1 35 feet (10.7 m) 27 feet (8.2 m)

2 30 feet (9.1 m) 21 feet (6.4 m)

3 25 feet (7.6 m) 17 feet (5.2 m)

4 20 feet (6.1 m) 15 feet (4.5 m)

NOTE: Deduct 6 feet (1.8 m) for each additional elbow.

Table 2

D8021