Service manual

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Troubleshooting
31
F8343001
10. Excessive Vibration and/or Noise During Spin (Sheet 2 of 2)
CHM492S-b
Is the washer-
extractor grouted
properly?
No
Properly grout washer-extractor. Refer to
Installation Manual for specifications.
Yes
Is the washer-extractor
anchored to a flat, level
surface with the proper
depth of concrete?
No
Remove and re-install washer-extractor correctly.
Refer to Installation Manual for specifications.
Yes
Are the front and rear
bearings making
excessive noise?
Yes
Replace the bearings as needed.
No
Lift up on the basket at the
front of the tub. Is there any
up and down play that would
indicate bearing wear?
Yes
Replace the bearings as needed.
continued from
previous page
Yes
Are motor and drive
pulleys aligned and on
tight?
Align/tighten pulleys as needed.
No
CHM492S-b