Operating instructions

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Operation
13
F232136
● EC:xx – When the computer senses a Card
Reader Communication error, the display will
read “EC:xx” where “xx” indicates the error
description as shown in Table 2.
● Right-most decimal point lit – When the
computer senses a network communication error,
the right-most decimal point will be lit.
Figure 11
Error
Display
Error
Description
:00 General communication error
:02 Timeout error
:03 Invalid command code
:05 Invalid or out-of-range data
:06 Invalid data code
:09 Corrupted data error
:0A Invalid machine type
:19 No Card Reader communication
:20 Unreadable card
:21 Security ID mismatch
:22 Site code mismatch
:23 Card maximum value exceeded
:24 Insufficient memory on card
:25 Card reader malfunction
:26 Card write error
:27 Diagnostic test card write failure
:28 Diagnostic test card read failure
:29 Diagnostic test Memory test failure
:2A Diagnostic test card interface failure
:2b Diagnostic test Flash checksum failure
:2C Bad Biberon or non-Biberon device
:2d Firmware update failed, s/w intact
:2E Firmware update failed, s/w not intact
:2F Firmware updated, but s/w not intact
:30 Timeout waiting for Biberon insertion
:31 Hotlisted card inserted into the reader
:40 No valid firmware in the card reader
:50 Loyalty purse read error
:56 Loyalty purse write error
Table 2
CHM2222N