Operating instructions

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Operation
11
F232136
Power Failure Recovery
If a cycle is in progress and the power fails, cycle
status is saved in memory (for a minimum of six years)
without power being applied.
If power resumes within 1 minute and 30 seconds, the
previously active cycle will continue without having to
press START.
If the control was in a fill cycle step and if the pre-
programmed pressure switch is not satisfied, the
control will start the Fill/Tumble step from the
beginning.
If the control was in an intermediate extract step, the
rest of the extract step is lost and the control will
resume in the next cycle step. However, if in the
intermediate extract step prior to the final extract or in
the final extract, the control will resume the cycle from
the beginning of the previous Drain/Tumble step.
If power resumes anytime after 1 minute and
30 seconds and less than or equal to the time
programmed by the owner for the Power Fail Reset,
or if the Power Fail Reset feature is disabled, the
control will enter into the START Mode at the
beginning of the cycle step where the power failed.
If power resumes anytime after the time programmed
by the owner, the control will revert to the READY
Mode. The Power Failure Recovery feature may be
modified by using the Micro-Wand IIIE.
Error Display Indications
An error is recoverable if normal machine function can
resume without having to shut off power to the
machine. See below for recoverable errors.
● Err – When an unrecognized coin is deposited in
coin meter, display will show “Err” and the
control will be locked out for five seconds. Any
valid coin deposits made during this time will
still be accounted for when access to the control
is restored.
● E:dL – When computer is having difficulty
controlling door lock mechanism, computer will
display “E:dL.” If computer is in START Mode
and operator presses START, computer attempts
to lock door. After 10 seconds, computer will
display “E:dL” while attempting to lock door for
one minute. After one minute, if door still isn’t
locked, computer stops trying. If any key is
pressed or door is opened, the display will
change back to the normal START Mode display.
In DOOR UNLOCK Mode, computer displays
“E:dL” after 10 seconds of trying to unlock door
for one minute. If any key is pressed, display
reverts back to Door Unlock display. Computer
again attempts to unlock door. Moving the door
handle will usually free the door lock and allow it
to be unlocked.
If door is sensed as unlocked during a cycle,
computer will display “E:dL” and terminate the
cycle. Computer must be powered down at this
point.